Part 16
drag and drop feature. If the point is touched, released and touched within a
short time interval, it will simulate double-clicking left button of the mouse.
Emulating the click on right button of a real mouse is further illustrated in
paragraph below.
Touch terminal manager
Before using the PS/2 interface resistive type touch control panel, one
must be aware that if you connect any monitor to the VGA port of HT system
for extended secondary display application,
you can not apply any touch
control function for this secondary display
due to driver conflict concerns!
The operation range of a PS/2 mouse is also limited within the primary display
area.
A program named “Posiflex Touch Terminal Manager” is installed in
the preloaded Windows system for the user to maneuver versatile features of
the touch terminal with a PS/2 interface touch panel controller. This program
can also be obtained by download from the POSIFLEX web site. However, the
installation process of this driver for Win XP and Win 2003 Server requires
some careful attention to the notice messages.
With proper setup and selection on control items in “Posiflex Touch
Terminal Manager”, a drawing representing a 2-button mouse will appear on
the desktop. Touch the right button in this drawing. Any touch on the screen
after this action will result in a right button mouse click at the point touched.
After touching the left button in this drawing the screen touch will resume the
left button function. This program also controls the beep generated when the
touch panel is touched, the detail in right button click emulation, and also
provides touch panel re-calibration. In principal, the touch panel requires no
further calibration once properly set.
CUSTOMER DISPLAY
The optional customer display PD-2601 or PD-7321 mounted on a
pole at rear corner of HT system can be turned horizontally for best viewing
effect in application.
SIDE MOUNT UPGRADE KIT BC-300/SD-300/KP-200
In SD-300 there may be the MSR for reading a magnetic stripe card
and/or the optical type finger print sensor. In KP-200 there may also be a MSR
and/or a smart card reader. The BC-300 is a bar code card reader.
For magnetic stripe card reading, be sure to insert the card to the
bottom with magnetic stripe facing the mark aside the slot. The movement of
the card can be either inserting the card from the top surface then sliding the
card down out of the slot, or sliding the card upward from the lower side of the
slot till it reaches the top end as long as the card is a standard one. A non-
standard card recorded without complete degaussing prior to recovery may
accept only one direction in card reading.
