Troubleshooting
ROBO-8911VG2A User’s Manual
5-6
Q4: I connect two IDE devices over one IDE flat cable, but the system either does
not start, or just hangs from time to time. Why ?
A:
Make sure that you have configured the two IDE devices as a master and a slave,
respectively.
Q5: I am using an ATA-66 (or 100) hard drive, how can I know that ATA-66
function is started??
A:
You need to use the 80-pin ATA-66 IDE flat cable to have this function ready.
During POST, you can see ATA-66 (or 100) message while hard drive is being
detected.
Q6: In addition to the above description, is there anything to do to finish up an
ATX system?
A:
Yes. ROBO-8911 needs to be configured to support ATX function for the above
cabling. Please move jumper JP4 to 3-5 short and 4-6 short (support ATX
function).
Q7: How can I build up an AT system using ATX power supply
A:
ROBO-8911 is able to emulation to AT system and power up automatically; Please
short a jumper cap on JP9 of ROBO-8911 to support AT function. Meanwhile, set
Bios setup menu “PWRON” after “PWR Fail” to auto power up function.
