BIOS Setup Information
ROBO-8911VG2A User’s Manual
4-1
Chapter 4
BIOS Setup Information
ROBO-8911VG2A is equipped with the Phoenix (AWARD) BIOS stored in Flash
ROM. These BIOS has a built-in Setup program that allows users to modify the basic
system configuration easily. This type of information is stored in CMOS RAM so that
it is retained during power-off periods. When system is turned on, ROBO-8911VG2A
communicates with peripheral devices and checks its hardware resources against the
configuration information stored in the CMOS memory. If any error is detected, or
the CMOS parameters need to be initially defined, the diagnostic program will
prompt the user to enter the SETUP program. Some errors are significant enough to
abort the start-up.
4.1 Entering
Setup
Turn on or reboot the computer. When the message “Hit <DEL> if you want to run
SETUP” appears, press <Del> key immediately to enter BIOS setup program.
If the message disappears before you respond, but you still wish to enter Setup,
please restart the system to try “COLD START” again by turning it OFF and then
ON, or touch the "RESET" button. You may also restart from “WARM START” by
pressing <Ctrl>, <Alt>, and <Delete> keys simultaneously. If you do not press the
keys at the right time and the system will not boot, an error message will be displayed
and you will again be asked to,
Press <F1> to Run SETUP or Resume
In HIFLEX BIOS setup, you can use the keyboard to choose among options or modify
the system parameters to match the options with your system. The table below will
show you all of keystroke functions in BIOS setup.
General Help
↑↓→
←
: Move
Enter :
Select
+ / - /PU /PD
: Value
ESC :
Exit
F1
: General Help
F2
: Item Help
F5
: Previous Values
F6
: Fail-Safe Defaults
F7
: Optimized Defaults
F9
: Menu in BIOS
F10 :
Save
