System Installation
ROBO-8773VG User’s Manual
3-4
CPU FSB
Bandwidth
800MHz 6.4GB/s
533MHz 4.2GB/s
Memory Frequency
Dual Channel DDR
Bandwidth
Single Channel DDR
Bandwidth
400MHz 6.4GB/s
3.2GB/s
333MHz 5.4GB/s
2.7GB/s
Note:
To maintain system stability, don’t change any of DRAM parameters in BIOS setup
to upgrade system performance without acquiring technical information.
Memory frequency / CPU FSB synchronization
ROBO-8773VG supports different memory frequencies depending on the CPU front
side bus and the type of DDR DIMM.
CPU FSB
Memory Frequency
800MHz 400/333*
MHz
533MHz 333
MHz
* When using 800MHz FSB CPU, DDR DIMMs may run at 320MHz (not 333MHz)
due to chipset limitation.
3.3
Installing the Single Board Computer
To install your ROBO-8773VG into standard chassis or proprietary environment,
please perform the following:
Step 1 : Check all jumpers setting on proper position
Step 2 : Install and configure CPU and memory module on right position
Step 3 : Place ROBO-8773VG into the dedicated position in the system
Step 4 : Attach cables to existing peripheral devices and secure it
WARNING
Please ensure that SBC is properly inserted and fixed by mechanism. Otherwise, the
system might be unstable or do not work due to bad contact of PICMG 1.0 PCI plus
ISA-bus slot.
Note:
Please refer to section 3.3.1 to 3.3.4 to install INF/VGA/LAN drivers.
