Trouble Shooting
ROBO-6710/6730VLA User’s Manual
5-7
Symptom: There is neither no beeps nor screen output.
Solution:
Indeed, you might want to check the system with the stand-alone to
identify the root cause by isolating the board from other possible system
devices such as PCI device, Backplane, and so on. If the system still cannot
boot up, please fill out RMA form which is provides on Portwell website,
and then send back to Portwell Inc. as a RMA goods. Besides, you also
visit RMA site (http://www.portwell.com.tw/rma/login.asp) to check
RMA report if necessary.
Backplane
ROBO-6710/6730 series is a half-sized Signal Board Computer, and therefore is only
able to run on PICMG PCI Backplane. To know whether your Backplane is PICMG
PCI Backplane, please contact with vendor or manufacturer.
Regard to our backplane products, the PBP-04P is the specification backplane that
made for the half-sized Single Board Computers. To use the backplane with ROBO-
6710/6730, please plug the half-sized Single Board Computer on the “CPU-SLOT”
which marked on the PBP-04P.
Please check the below picture for the backplane. (See Figure 5-11) In the picture,
you can see the marked “CPU-SLOT” and the 4-Pin ATX power connector. Please
follow the above instructions to connect the SBC with the backplane.
Figure 5-11
