Trouble Shooting
ROBO-6710/6730VLA User’s Manual
5-1
Chapter 5
Trouble Shooting
This chapter provides you a few useful tips to quickly get your ROBO-6710/6730
running with no failure. As basic hardware installation has been addressed in
Chapter 3, this chapter will basically focus on system integration issues, in terms of
backplane setup, BIOS setting, and OS diagnostics.
5.1
Quick installation Guide
Power connector
ROBO-6710/6730 series requires power drawing from the power connectors (CN1),
please connect the IDE Peripheral power connector. If this connector is not
connected, then the system might fail to boot up.
(Figure 5-1) !!
Figure 5-1
ATX Power Setting
This section would be more likely to introduce you how to set up ATX mode on your
ROBO-6710/6730 series. This setting is for you when use the backplane with the
system board. Please refer to the following instruction.
Step 1: If you want to use ATX mode, please removed the jumper on pin 3 (PS-ON)
and pin 4 (GND) of backplane ATX P/S control connector. And connect 4
pins power cable to the 5VSB Header For ATX. (Figure 5-2) Basically, our
backplane products have the default setting to set the jumper on the AT
mode.
