Portek ULTRA Mk2, Инструкция по эксплуатации

Страница: 5 / 12

WARNING: Before connecting the machine to the mains power, make
sure the machine is switched ‘OFF’ to avoid unintended starting!
1. Inspect the chain for the most worn-out cutter tooth and start sharpening with this
tooth. The most worn-out tooth is important in order to sharpen all other teeth to the
same depth!
2. Lift up the chain stop.
3. Check the necessary angle according to the specifications for the chain (see table).
Adjust the top plate cutting angle to 60° - 50° and retighten fixing screw.
4. Adjust the filing angle on the chain holder assembly to 25° - 35° or to the required
angle and tighten the adjustment screw for the vice angle.
5. Tighten the chain between the metal guide boards. Fold down the chain stop and pull
back the first cutter tooth against the chain stop.
6. Check the alignment is correct. Using the handle pull down the grinding wheel to
meet the cutter tooth. For fine adjustment of the chain position use the chain stop
adjustment screw. If the position is correct, fix the position with the locking screw.
Fine adjustment of the chain stop have to be made with the screw for lateral
adjustment.
7. If necessary the distance of the guide boards can be adjusted with the set screw. By
doing this the chain will be securely fixed in position while using the fastening lever.
Make sure the chain is between both guide boards. Both guide boards have to be so
closely connected that the chain can not tilt to the side.
Operation of ULTRA Mk2
ULTRA_operators booklet.qxd:Layout 1 11/09/2013 05:36 Page 5