10/07/08
Page 1 of 4
U:\Judy\INSTRUCTIONS CURRENT\INSTR LIFT ACCESSORIES\A22 INSTR CANOPY UNDER 1200 AND 36114.doc
PORTA-LIFT CANOPY TOP
1155, 1265, 1284, AND 36114
Thank you for purchasing our product!
*Please read these instructions and follow them step by step.*
Caution-- If installing or adjusting a canopy mounting bracket on a lift with an existing winch the bed must be lowered
with the load removed from the bed before the winch is taken off.
Step 1.
Set the four canopy mounting brackets
(REF. # 6)
into the top of each vertical upright of the side member so that the
weld on the side of the channel is to the outside of the lift. Set to desired height using bolts, washers, & nuts
(REF. # 10, 13, &
7).
Step 2.
Set the four canopy sections together with the two stubbed sections (1265 canopy sections do not have stubs)
(REF. #
1)
in opposite corners. Slide the stubbed ends into the open-end tube sections
(REF. # 2)
and bolt with 3/8" X 2 1/2" bolts,
washers, & nuts
(REF. # 3, 13, & 7). NOTE: 1265 models will have four fewer bolting locations than the larger canopy
shown in the instruction.
6 - 53