A
B
C
D
E
F
G
H
I
J
K
L
M
N
O
P
Q
R
S
T
U
V
W
X
Y
Z
24
Car Alarm
If the vehicle alarm system is triggered, a push noti-
fication with information on the type and time of the
alarm is sent directly to the cellphone.
Location-, Speed- and Valet Alarm
1.
Select
My Car
in the app main area.
2.
Move down by swiping downwards (
Alarms and
Modes
).
3.
Select
Change settings
.
4.
Select the desired alarm.
–
Location:
A geographical area can be defined. If
the vehicle enters or leaves this area, an alarm
message is sent.
–
Speed:
A limit speed is specified. If this limit
speed is exceeded, an alarm message is sent.
–
Valet:
A preconfigured combination of the Loca-
tion and Speed Alarm can be activated. If a pa-
rameter is exceeded, an alarm message is sent.
Geographical areas and limit speeds can be added
and activated via the
Add alarm
function.
Stored geographical areas and speed limits can be
edited or deleted via the
Edit
function.
Information
Changes to limit settings affect all app users that
access the same vehicle.
Setting precool/heat functions
The vehicle's precool/heat function can be operated
remotely using the app. Depending on the equip-
ment, advanced settings can be configured, e.g. seat
heating can be activated.
The availability of the function depends on the ve-
hicle type and configuration. Further information is
available from an authorized Porsche dealer.
The following conditions must be met to use the full
scope of functions in the app:
b
b
Private mode is deactivated.
b
b
Remote access authorization granted in the
PCM.
>
Please see chapter "Installing & using" on page 3.
b
b
Battery is sufficiently charged (<10 %).
Immediate start
Precool/heat can be activated and deactivated
immediately.
The desired temperature can be specified.
1.
Select
My Car
e
A/C
in the app's main area.
2.
Select
Start
.
The precool/heat function is immediately
switched on and adopts the standard temper-
ature set in the app. Precool/heat ends after 60
minutes.
Information
– Air flow and air distribution are regulated auto-
matically, irrespective of which settings were
active when the vehicle was parked.
– The precool/heat function in your vehicle is only
activated when the high-voltage battery is suffi-
ciently charged. For further information on the
high-voltage battery charging process, please
refer to the separate Owner’s Manual.
– Please note that the charge status of the high-
voltage battery can be reduced or the charging
process delayed by precooling/heating.
Seat heating/seat ventilation
Seat heating/seat ventilation can be started and
stopped immediately.
e
Select
My Car
e
A/C
in the app's main area.
Seat heating/seat ventilation can be switched
on or off by tapping the respective buttons.
Seat heating/seat ventilation is started imme-
diately and adopts the last temperature set in
the vehicle.
Information
The timer uses the set time in the vehicle, not the
time of the cellphone.
Using E-Control
Using the app, you can remotely control the charging
process for your vehicle and display the current
status.
Information
For further information on the high-voltage battery
charging process, please refer to the separate Own-
er’s Manual.
Direct charging
The charging process is started immediately at the
maximum charging rate. All active timers and pro-
files are not taken into account.
b
b
Private mode is deactivated.
b
b
Remote access authorization granted in the
PCM.
>
Please see chapter "Installing & using" on page 3.
b
b
Charging equipment connected.
