188
Parking
Deactivating ParkAssist
On vehicles with front and rear ParkAssist, the
ParkAssist function can be deactivated manually.
f
Press button
A
on the overhead operating
console.
The indicator light in the button lights up.
ParkAssist is switched off.
Display due to environmental factors
Correct operation is no longer guaranteed if there
is a temporary fault (e.g. caused by ice formation
or heavy soiling on the sensors).
Depending on the environmental factor, it is
possible that a stop warning with acoustic warning
or a warning triangle without acoustic warning is
displayed on the central screen of the Porsche
communication system.
ParkAssist is ready for operation again when the
interference has been eliminated.
In the event of a
permanent fault
in ParkAssist,
a continuous tone sounds for three seconds after
reverse gear has been selected.
On vehicles with front and rear sensors only:
In the case of a sensor problem, a warning triangle
appears in the monitoring area for the relevant
bumper and a continuous tone sounds for three
seconds.
Possible cause:
– Defect or system fault.
f
Have the fault corrected. Please contact an
authorized Porsche dealer.
Reversing Camera
The reversing camera is located between the
number plate lights in the bumper (
illustration
).
f
Please see chapter “REVERSING CAMERA” in
the separate PCM/CDR operating instructions.
f
Always keep the reversing camera clean and
free of ice and snow so that vision is not
impaired.
f
Please see the chapter “CAR CARE
INSTRUCTIONS” on page 210.
14_C7NF_21.book Seite 188 Mittwoch, 26. März 2014 12:15 12
