Porsche 911 GT3 Cup MR Gen. II, Техническое руководство

Страница: 10 / 120

10 Version V2, 08/2020 Porsche 911 GT3 Cup MR Gen.II
Home
ENGINE | Central Radiator
1.3 Central Radiator
NOTE
►
A central water radiator is used on the 911 GT3 Cup MR Gen.II. The series - moderate water cooler
(3 pieces) are no longer installed. This means that the vehicle is better protected against radiator
damage when touched, even in close proximity battles on the race track.
►
Like in the 911 GT3 Cup Gen.II, the cooling system is thermostat controlled. The blanking of the
The connectors and the ventilation line must be checked for correct
fitting and chafing points before each session.
Only coolant antifreeze approved by Porsche AG may be used. The
specified mixing ratio for the 911 GT3 Cup Gen.II has to be used.
10 Nm
10 Nm
10 Nm
10 Nm
NOTE
The hose clamps for the connectors may only be used once. Never
retighten them! The specified tightening torque of 3 Nm must be ob-
served.
3 Nm
3 Nm
NOTE
The four rubber brackets on the radiator holders must be checked for
damage before each event and replaced if necessary.
ATTENTION
In the event of loss of coolant, all components of the cooling system
must be checked for damage. Checking tools (see technical manual
from Porsche AG) may have to be used. Failure to do so can damage
the engine due to overheating.
High water temperatures and high water pressure!
Risk of injury from burning.
Allow the system to cool down before starting work !
WARNING