3
3. Wiring Instruction
The SPA has been assembled before delivery, you only need to connect it to the power supply to use it.
There are two ways of connecting the wires for Balboa system: 220V one-phase and 380V three-phase. For a better
user experience, Pooli has chosen the 380V three-phase. There are 5 wires that need to be connected: 3 fire wires, 1
neutral wire and 1 ground wire.
3.1.Find the Electrical Box and the Inlet
The electric box is located inside the removable skirt board. You will find the following stickers on the board.
To open the skirt board, you need a pliers and a screwdriver.
1) Remove the gray screw cap at the bottom of the skirt board (use pliers if it’s tight) , remove the screw with a
screwdriver.
2) Hold the bottom of the skirt board with both hands and pull it out. (Note: The weight of the skirt is about 5KG)
3.2.Connect to your power supply
1) Open the electric box, you will see a detailed circuit diagram attached to the back of the cover. Please refer to the
small picture in the bottom left corner (230V 3P 3*16A) to connect to 380V. As shown in the picture below:
Содержание OS030994B
Страница 1: ...Article No OS030994B PRODUCT MANUAL...
