6
POOL FROG
XL PRO CYCLERS
A. With High Flow Rate
(greater than 80 gpm)
Install T-fittings exactly as shown.
Installation Tips to Ensure Proper Performance
C. Pool and Spillover Spa Combination
B. With In-Floor Cleaner - TWO OPTIONS
✙
✙
✙
✙
✙
Flow
Flow
The best option is to have two lines.
One line with pump, filter, heater and
POOL FROG XL Pro Cyclers and a second line with a separate pump for the
in-floor cleaning system (filter optional).
OPTION 1- A Two-Line Installation
OPTION 2 - A 3-Way Valve Installation
POOL WATER LEVEL
POOL RETURN
3-way manual valve or 3-way motor valve plus controls
POOL FROG
XL PRO CYCLERS
POOL FROG
XL PRO CYCLERS
IN-FLOOR
CLEANER
VALVE
IN-FLOOR
CLEANER
VALVE
FILTER
FILTER
FILTER
HEATER
PUMP
PUMP
PUMP
Line 1
Line 2
WARNING
• Do not exceed maximum operating pressure of 50 psi.
• Do not install automatic or fast shut off valves
downstream of Cyclers.
• Always install the POOL FROG XL Pro Cyclers AFTER
the heater (if applicable) on the return line.
• Always install any additional sanitizing equipment
AFTER and NEVER BEFORE the POOL FROG XL Pro
Cyclers are installed on the return line.
1) If using a multi-speed pump, run pump for at least
6 hours per day at high speed (at least 40 gpm).
If the pump will run on low speed 24
hours per day or less than 6 hours
per day on high speed, you must
bleed the air while the pump is on by
unscrewing both Cycler cap knobs
until water appears from both Cyclers.
Then screw the knob back on. Repeat
this process each time the cap is
removed for any reason.
2) Install Cyclers with 4-8 psi back pressure.
Lower back pressures could result in under
chlorination. Change the eyeball fittings in
the return jets to a smaller size to increase
back pressure. Contact King Technology at
800-222-0169 for a specially designed Cycler
pressure gauge to determine back pressure
at pool start-up.
3) Special installation Requirements:
IMPORTANT:
Over chlorination or damage to the POOL
FROG XL Pro Cyclers or other equipment could result
if special installations A, B or C are not used in these
situations.
•
If water flow is higher than 80 gallons per minute (gpm),
see diagram A.
•
If an in-floor cleaner is included with pool,
see diagram B, with two options. Preferred
installation is Option 1 with two separate lines.
•
If set-up is a pool and spa combination with
common equipment, see diagram C.
Questions?
Call Customer Service at 800-222-0169
Monday thru Friday, 8 am to 5 pm central standard time.
Before installing, read all directions carefully and contact your dealer for installation support
