PAC2000B Power Amplifier User Manual
16
5.2 Rear Panel
5
7
12
11
8
6
9
10
5.
Power socket:
Please use the power cable supplied by PONOVO (The cable with
special port must be used).
6.
Control supply terminals of current amplifier:
Please refer to the terminal definition
below.
7
＊
.
Current output:
It is connected with the current input of the test object.
8.
Earth ground:
It should be grounded with earth during testing.
9
＊＊
.
Gain selection:
There are three options for choice and the related indicators for
Gain selection will be on in front and rear panels.
10
＊＊＊
LPF:
Low-pass filter
Test:
It is used for calibration purpose.
11.
Current Signal Input:
0~7V RMS (±10Vpek)
12.
Control terminals of current amplifier:
Please refer to the terminal definition below.
＊
:
There are both current output in the front and rear panels. Current output on either
panel can be configured.
＊＊
:
Once the output is in process, the gain selection cannot be changed.
＊＊＊
:
LPF:
A low-pass filter (LPF) is a filter that passes signals with a frequency lower than
a selected cutoff frequency and attenuates signals with frequencies higher than the cutoff