PONNDORF Gerätetechnik GmbH
Leipziger Strasse 374
D - 34123 Kassel
Operation manual
Hose Pump type
P_high pressure 65
Page 22 of 26
Version 002_GB / 05.2017
13)
The casing must be filled up with
lubricant bath to the lower edge of
inspection glass at least, superior to
the half.
Pump is now ready for operation !
It must be secured that there are no remains of the pumping medium left in
the pump hose (medium could run out or spray).
Especially in case of aggressive and caustic media there is danger of
injuries !
The casing cover may only be removed when the drive is switched off and
the power supply is interrupted (remove fuses).
Before starting the pump it must be secured that any valves assembled in
the pipework (on suction and discharge side) are opened.
Otherwise the pump or parts of the pipework could be damaged by too high
increase of pressure.
If the pump is equipped with a hose leakage detector it must be secured
that the sensor is unpolluted because deposits on the sensor could cause
malfunctions of the detector.
CAUTION
CAUTION
