Product Max. Circumference
A Series
A-0
25.1 in.
63.8 cm
A-1
34.5 in.
87.7 cm
A-2
45.5 in. 115.6 cm
A-3
53.4 in. 135.6 cm
A-4
64.4 in. 163.5 cm
A-5
84.8 in. 215.3 cm
A-6
106.8 in. 271.2 cm
A-7
122.5 in. 311.0 cm
F Series
F-1
18.8 in.
47.9 cm
F-02
23.6 in.
59.8 cm
F-2
25.7 in.
65.4 cm
F-3
25.7 in.
65.4 cm
F-4
26.7 in.
67.8 cm
F-5
34.5 in.
87.7 cm
F-6
34.5 in.
87.7 cm
F-7
47.1 in. 119.6 cm
F-8
47.1 in. 119.6 cm
F-10
56.5 in. 143.6 cm
F-11
66.6 in. 169.1 cm
F-13
91.1 in. 231.3 cm
Product Max. Circumference
G Series
G-3
17.3 in.
43.9 cm
G-4
20.4 in.
51.8 cm
G-5
27.6 in.
70.2 cm
G-6
34.5 in.
87.7 cm
HTM Series
HTM-1
19.8 in.
50.2 cm
HTM-2
26.7 in.
67.8 cm
HTM-3
33.0 in.
83.7 cm
HTM-4
42.4 in. 107.7 cm
LD Series
LD-1
27.0 in.
68.6 cm
LD-2
36.1 in.
91.7 cm
LD-3
42.4 in. 107.7 cm
LD-4
48.7 in. 123.6 cm
WS Series
WS-1
25.1 in.
63.8 cm
Note: Remove white plastic screw from the valve (located
near the ropehold). When inflating with an air compressor,
set the psi to 2 lbs. pressure.
INFLATION CHART
INFLATION
Polyform products are designed to be inflated to 2.1 lbs/0,15 bar of pressure. When inflating with-
out a pressure gauge, fill the buoy or fender until the walls are fully expanded, but make certain
you can depress the wall at least 1/4 inch with light hand pressure. Measure the circumference and
compare it with the inflation chart for proper pressure. Over inflation will reduce the performance of
the product and may cause premature failure. Over inflation voids the warranty.
