POLTI lecoaspira vaporetto FAV50 multifloor, Инструкция по эксплуатации

Страница: 41 / 120

15.3 Bend and break the phial cap.
15.4 Pour the contents of the phial into the
water filter collector of the appliance.
16. GENERAL MAINTENANCE
To clean the outside of the appliance, only
use a damp cloth and tap water.
All accessories can be cleaned using running
water, ensuring they are completely dry
before the next use (37).
Do not use detergents of any type.
17. CLEANING THE WATER FILTER
COLLECTOR
(ordinary maintenance)
17.1 Ensure that the appliance is switched off
and disconnected from the mains.
17.2 Lift the water filter collector removing it
from its housing using the special handle (2).
17.3 Turn the handle backward and remove
the water filter unit (3-4).
17.4 Empty the tank by tilting it towards the
spout (35).
17.5 Turn the elbow tube downward until it
slides off the filter unit (36).
17.6 Separate all the components and rinse
them under running water (37).
17.7 Dry the various components of the filter,
reassemble it (38) and reinsert it into the dirt
collector.
17.8 Reposition the water filter collector in the
appliance.
18. CLEANING THE HEPA FILTER
(extraordinary maintenance)
18.1 Ensure that the appliance is switched off
and disconnected from the mains.
18.2 Lift the water filter collector removing it
from its housing using the container handle
(2).
18.3 Lift the release lever of the HEPA filter
and remove it from its housing (39).
18.4 Rinse the HEPA filter using running water
only and shake gently to remove any excess
dirt or water residue; before replacing the fil-
ter in the appliance, leave to dry naturally
away from sources of heat for at least 24
hours.
The HEPA filter should be fully cleaned ap-
proximately three times per year.
19. SPARE SEALS
Periodically check the status of the coloured
washer located in the built-in socket. If neces-
sary, replace with the corresponding spare
part, as described below.
Perform the same check on the connection
seals of the extension tubes and the handle of
the hose. If necessary, operate as follows.
20. STORAGE
20.1 Turn off the appliance and disconnect
from the mains electricity.
20.2 Remove the water filter collector as indi-
cated in Section 1.
Use 1 phial per use.
A possible change in the colour of the liquid
does not alter the functioning or the efficacy
of the product.
WARNING: Never poor Bioecologico into
the boiler.
WARNING: Check the filters during cleaning.
Replace the filters when visibly damaged.
To clean the water filter collector and the
extension tubes, if they are especially dirty,
once the cleaning operations have been
completed, empty the container as descri-
bed and replace it in its housing in the ma-
chine. Connect the appliance to the mains.
Then vacuum up approximately 1.5 litres of
clean water using the suction function for a
few seconds. The water vortex created insi-
de the collector will rinse the sides and re-
move any dirt. The clean water will also
clean the inside of the tubes as it travels th-
rough them. Empty the collector again and
put Vaporetto Lecoaspira away.
WARNING: Check the filters during cleaning.
Replace the filters when visibly damaged.
WARNING: Do not clean the filter with the
brush as it can be damaged, thereby redu-
cing its filtering capacity. Do not use deter-
gents, do not rub the filter, and do not wash
it in a dishwasher.
- Remove the damaged washer.
- Insert the new washer, attaching it
on the steam nozzle and pushing it
into place.
- Lubricate the gasket with silicone
grease or Vaseline, or alternatively
with small quantities of vegetable
oils.
- Remove the damaged washer.
- Insert the new washer, applying it on
the steam nozzle and pushing it into
place.
- Lubricate the gasket with silicone
grease or Vaseline, or alternatively
with small quantities of vegetable oil.
E
N
G
L
IS
H
| 41 |