114
MAINTENANCE
Headlight Lamp Replacement
Trail Blazer, Sport
1.Remove front cover and unplug the light harness.
2.Remove rubber cap from back of headlight to reveal retention screw.
3.Remove small phillips head screw, and carefully remove bulb from housing.
4.Insert new bulb into housing and tighten retention screw, install rubber cap.
5.Reconnect light harness.
6.Install cover to machine.
7.Properly adjust headlight aim.
Headlight Adjustment
1.Place the vehicle on
a level surface with
the headlight
approximately 25’
(7.6 m) from a wall.
2.Measure the dis-
tance from the floor
to the center of the
headlight and make
a mark on the wall
at the same height.
3.Start the engine and
turn on headlight.
4.Observe headlight
aim. The most in-
tense part of the
headlight
beam
should be aimed 8
″
(20.3 cm) below the mark placed on the wall in step 2.
NOTE:
Rider weight must be included on the seat.
5.Adjust beam to desired position by turning adjustment screws in headlight cover.
Turning right screw clockwise moves the intense spot of light up to the left.
Turning the left screw clockwise moves intense spot of light up to the right.
Turning the bottom screw clockwise adjusts the light upwards.
Headlight
adjustment
Screws
Headlight
adjustment
Screw
Содержание Universal ATV 2000
Страница 12: ...4 SAFETY WARNING AND OPERATION DECALS 1 7077919 E1997...
Страница 13: ...5 SAFETY WARNING AND OPERATION DECALS 2...
Страница 15: ...7 SAFETY WARNING AND OPERATION DECALS 4 7 6 7 3 5...