Polaris RZR PRO XP 2020, Руководство по обслуживанию

Страница: 253 / 598

4
9850068 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual
© Copyright Polaris Industries Inc.
4.7
CRANKSHAFT POSITION SENSOR (CPS)
OPERATION OVERVIEW
Mounted on top of the stator cover, the crankshaft
position sensor
q
is essential to engine operation,
constantly monitoring the rotational speed (RPM) and
position of the crankshaft.
A ferromagnetic 35-tooth encoder ring with a missing
tooth is built onto the flywheel. The inductive speed
sensor is mounted 1.0 ± 0.26 mm (0.059 ± 0.010 in.)
away from the encoder ring. During rotation, an AC pulse
is created within the sensor for each passing tooth. The
ECU calculates engine speed from the time interval
between the consecutive pulses.
The encoder ring missing tooth creates an “interrupt”
input signal, corresponding to specific crankshaft
position. This signal serves as a reference for the control
of ignition timing by the ECU. Synchronization of the
CPS and crankshaft position takes place during the first
two revolutions each time the engine is started. This
sensor must be properly connected at all times. If the
sensor fails or becomes disconnected for any reason, the
engine will stop running.
CPS TEST
The CPS is a sealed, non-serviceable assembly. If fault
code diagnosis indicates a problem with this sensor, test
as follows:
1. Locate the CPS harness connector above the
transmission on the RH side of the vehicle and
disconnect the harness.
2. Pin
q
is for the shield circuit and it should be OL to
pins
w
&
e
. A resistance reading would indicate a
shorted sensor.
3. Connect an ohmmeter between CPS pin terminals
w
&
e
. A resistance value of 1000Ω ± 10% at room
temperature should be obtained.
CPS Resistance Specification:
1000Ω ± 10%
4. If the resistance is correct:
• Test the main harness circuit between the sensor
connector terminals and the corresponding pin
terminals at the ECU (see wiring diagram).
• Check the sensor mounting, air gap, flywheel encoder
ring for damage or runout, and flywheel key. Follow the
CPS Replacement procedure to inspect CPS and
flywheel encoder ring for damage.
5. If the resistance is incorrect, follow the CPS
Replacement page 4.8 procedure.
ENGINE ELECTRICAL