![Polaris RZR PRO XP 2020 Скачать руководство пользователя страница 115](http://html1.mh-extra.com/html/polaris/rzr-pro-xp-2020/rzr-pro-xp-2020_service-manual_1572299115.webp)
9850068 R01 - 2020-2021
RZR
PRO XP / XP 4 Service Manual
© Copyright Polaris Industries Inc.
2.29
ENGINE OIL AND FILTER CHANGE
WARNING
Spilled oil and flammable cleaning products left on
engine components or in the engine area may pose a
fire hazard. Use shop rags to clean any spilled oil. If
needed, use a non-flammable solvent on the rag to aid
the cleaning process. Do not use any device such as
pressurized water or air as this may disperse the oil
onto engine components and could pose a fire hazard.
Always change engine oil and filter at the intervals
outlined in the Periodic Maintenance Chart.
1. Position vehicle on a level surface and place
transmission in PARK.
2. Allow engine to cool down before draining oil.
3. Place a drain pan under the engine crankcase and
remove the drain plug
q
.
4. Access the oil filter through the driver’s side rear
wheel well.
NOTICE
The engine should be off for at least 2 minutes prior to
removing the oil filter.
5. Place shop rags under the filter to catch any spilled oil
during removal. Using the Oil Filter Wrench, turn the
oil filter counter-clockwise to remove it. Tip the open
end of the oil filter up to minimize oil spill. Ensure all
shop rags are removed after cleaning up any spilled
oil.
Oil Filter Wrench:
PU-50105 (2.5″/64 mm)
6. Clean the filter sealing surface on the engine
crankcase with a clean rag and ensure the original oil
filter o-ring is not stuck to the crankcase.
7. Lubricate the o-ring on the new oil filter with a film of
clean engine oil. Check to make sure the o-ring is in
good condition. Tighten to specification.
TORQUE
Oil Filter:
Turn by hand until filter O-ring contacts sealing
surface, then turn an additional 3/4 turn.
8. Inspect the sealing washer on the drain plug for burrs
or nicks. Replace the washer if it is damaged.
9. Reinstall the engine crankcase drain plug. Torque
drain plug to specification.
TORQUE
Engine Oil Drain Plug:
12 ft-lbs (16 Nm)
10. Remove the cargo box. Add engine oil through the oil
fill cap
w
located on top of the engine valve cover.
11. Fill the engine to the recommended specification.
FLUID CAPACITY
Recommended Engine Oil:
PS-4 (PN 2876244)
Ambient Temp Range: -35° F to 100° F
PS-4 Extreme Duty (PN 2878920)
Ambient Temp Range: 0° F to 120° F
Capacity:2.75 qt (2.6 L)
12. Start engine and allow it to idle for 30 seconds.
13. Stop the engine and inspect for oil leaks. Wait at least
15 seconds before removing the oil dipstick.
Содержание RZR PRO XP 2020
