Polaris robotic NEO EM27 Series, Руководство пользователя

Страница: 5 / 48

Page 5
English
To Connect:
• Seat the control unit firmly in the control unit base.
1
"CLICK"
2
Figure 1. Connect Control Unit Base
• Rotate the power cord so that TOP is shown on
the top side. Press the power cord firmly into the
control unit until you hear a "click". The clicking
indicates the power cord is connected correctly
creating a watertight seal.
1
"CLICK"
"CLICK"
"CLICK"
"CLICK"
2
Figure 2. Connect the Power Cord
To Disconnect:
• Grip the power cord firmly on each side and press
two tabs to release.
Figure 3. Disconnect the Power Cord
Section 4. Operation
CAUTION
To prevent damage to the cleaner, be sure to adhere to
the following guidelines:
• Remove the cleaner from the pool after the cleaning
cycle is completed and store on the caddy out of direct
sunlight or inclement weather.
• Never lift the cleaner out of the pool by the floating
cable. Always use the handle to remove cleaner from
the pool.
• Take additional care when lifting the cleaner out of the
pool. It becomes heavier when filled with water.
• Always remove the cleaner from pool when super
chlorinating or adding acid.
• Do not handle cleaner while it is in operation.
IMPORTANT
• Always make sure the cleaner head is fully submerged
before you begin operation.
• Clean the filter canister after each cleaning cycle.
• Do not leave your cleaner in the pool on a permanent
basis.
• At the end of each cycle, remove the cleaner from the
pool. Start at the cleaner head and untangle any coils
in the cable before storing the cleaner.
The Polaris robotic cleaner includes a safety feature
that automatically stops the cleaner if it is powered on
but not submerged in water. For pools equipped with a
beach area, this safety feature is programmed to drive
the cleaner in reverse and back into the pool when the
impeller is out of the water.