Polaris RANGER EV 2015, Руководство по обслуживанию

Страница: 93 / 247

4
9926595 R01 - 2015-2016 RANGER EV Service Manual
© Copyright Polaris Industries Inc.
4.13
2. Lift the cargo box into the dump position.
3. Disconnect the rear wire harness attached to the tail
lights.
4. Remove the upper clip
w
and pin
e
attaching the
shock to the cargo box.
CAUTION
Safely support the box during the remainder of the
removal process. The box is not as stable with the
shock removed.
5. Remove the hinge pin from both sides.
CAUTION
Safely support the box during the remainder of the
removal process. The box is not as stable with the
hinge pins removed.
6. With both hinge pins removed, remove the box from
the frame. Two people may be needed to remove the
box from the frame.
CAUTION
Use caution when removing the box. It is recommended
to have two people carefully remove the box from the
frame.
CARGO BOX INSTALLATION
1. If the shock was replaced, install the lower portion of
the shock to the frame and secure it with the pin and
clip.
2. Place the cargo box onto the frame. Align the hinges
of the box with the bracket on the frame.
3. Install the box hinges on both sides.
4. Secure the box hinges with the hinge screws on both
sides.
5. With the hinges installed, attach the shock to the
cargo box by inserting the pin and clip.
6. Lower the box and secure the latch.
HOOD / DASH
1. Hood Removal - Unlatch the hood and disconnect
the head lamp harnesses. Remove the two clips and
pivot pins retaining the hood and remove the hood
from the bumper.
2. Dash Removal (continued) - Remove the three
Torx-head screws retaining the front of the dash to
the frame.
3. Open the glove box and remove the Torx-head screw
from the dash.
4. Remove the Torx-head screw retaining the left
portion of the dash.
5. Remove the eight fasteners from each side of the
dash where it attaches to the front and rear fenders.
6. Remove the rubber boot from around shift lever.
7. Remove the five push rivets from under the dash
panel. Unhook all electrical components to allow the
panel to be completely removed.
8. Carefully remove the dash assembly from the
vehicle.
FLOOR
1. Remove the Foot pads.
2. Remove the rear fender push rivets.
3. Remove the seven Torx-head screws retaining the
center floor.
4. Remove the Torx-head screws retaining the front
floor cover.
BODY / STEERING / SUSPENSION