59
CONTROLS AND FEATURES
Features
Exclusive AWD System (All Wheel Drive)
Engage the Demand 4 Drive switch before getting into conditions
where front wheel drive may be needed. If the rear wheels are
spinning, release the throttle before turning the Demand 4 Drive switch
on.
Disengaging Wheel Hubs
When backing up while in Demand 4 Drive and then going forward,
one or both hubs may remain engaged. If one or both hubs remain
engaged they can be disengaged by stopping, shifting to and moving in
reverse. Then proceed in forward again.
You can tell if only one front hub is engaged if the handlebars pull to
one side. If both front wheel hubs are engaged, steering effort
increases but remains balanced from left to right, and vehicle speed is
somewhat restricted.
NOTE:
If the hubs remain engaged after following these instructions
return the ATV to your dealer for service.
Switches
The light switch is located on the left hand handlebar. In addition to
turning the lights on and off, it also switches the lights from Hi to Lo
on models equipped with Hi-Lo beams.
NOTE:
The lights will not
work unless the key is in the on position and shut off switch is in the
“run” position.
If both hubs were engaged and only one released during
operation, loss of control could result. If you experience hub
engaging symptoms, use the above disengaging technique before
proceeding. Failure to disengage front hubs as directed above
could result in severe injury or death.
WARNING
Содержание ATV 2002
