Polaris 340 LX 2007, Руководство по обслуживанию

Страница: 107 / 327

5.3
ENGINE
5
Exhaust Valve Disassembly
1. Remove the vent lines from the exhaust valve base(s).
2. Remove the four cover fasteners (1) securing housing and
the valve assembly onto the cylinder.
3. Remove exhaust valve assembly from cylinder.
4. Remove the exhaust valve base gasket(s) (8) and discard.
5. To remove the guillotine (9), secure the guillotine, then
apply heat to remove the bellows retaining nut cap nut (4).
6. Separate the cap nut, bellows (5) and bellows washer (6)
from the guillotine.
7. Remove the guillotine from the base (7).
Exhaust Valve Assembly
1. Clean the threads of the guillotine with Primer N.
2. Insert the base (7) into the clean guillotine (9).
3. Apply Loctite 242 to first 3 threads on the guillotine.
4. Place the bellows washer (6), bellows (5) and cap nut (4)
onto the guillotine.
5. Torque the cap nut(s) to 16 ft-lb (22 N-m).
6. Lubricate the guillotine blade and shaft with engine oil.
7. Actuate the guillotine to ensure full and free motion.
8. Install the spring, and cover.
9. Torque the cover/base fasteners to 12 ft-lb (16 N-m).
Optional Exhaust Valve Springs
Reed Valve Disassembly
1. Loosen up the hose clamps (1)
2. Remove the carburetor(s) or the throttle body from the
intake boots (4).
3. Remove the intake boot fasteners (2) and hose holders (3)
(if applicable).
4. Remove the intake assembly (4-7).
CAUTION
EV spring under tension. Use care when removing
housing from assembly base.
= T
Guillotine Cap Nut Torque: 16ft.lb. (22 N-m)
= T
Cover/Base Fastener Torque: 12 ft.lb. (16 N-m)
SPRING # COLOR FREE LENGTH
7041704-01 Blue 1.752
7041704-02 Orange 1.729
7041704-03 Pink 1.734
7041704-04 Purple 1.726
7041704-05 Yellow 1.734
7041704-06 White 1.537
(12.2 N-m)
9 ft-lb
1
2
4
5
6
3
7
600 Carb
600 CFI
1
2
4
5
6
7