Polaris 2014 Sportsman 570 EF, Руководство по обслуживанию

Страница: 409 / 456

10
10.29
9924871 R03 - 2014 Polaris Sportsman® 570 EFI Service Manual
© Copyright 2013 Polaris Sales Inc.
CHARGING SYSTEM
Current Draw - Key Off
Do not connect or disconnect the battery cable or
ammeter with the engine running. Damage will occur to
electrical components.
Connect an ammeter in series with the negative battery
cable. Check for current draw with the key off. If the draw
is excessive, loads should be disconnected from the
system one by one until the draw is eliminated. Check
component wiring as well as the component for partial
shorts to ground to eliminate the draw.
Break Even Test
CAUTION
Do not connect or disconnect the battery cable or
ammeter with the engine running. Damage will occur to
electrical components.
The “break even” point of the charging system is the
point at which the alternator overcomes all system loads
(lights, etc.) and begins to charge the battery. Depending
on battery condition and system load, the break even
point may vary slightly. The battery should be fully
charged before performing this test.
WARNING
Never start the engine with an ammeter connected in
series. Damage to the meter or meter fuse will result.
Do not run test for extended period of time. Do not run
test with high amperage accessories.
1. Connect a tachometer to the engine.
2. Using an inductive amperage metering device, (set
to DC amps) connect to the negative battery cable.
3. With engine off and the key, kill switch, and lights in
the ON position, the ammeter should read negative
amps (battery discharge). Reverse meter lead if a
positive reading is indicated.
4. Shift transmission into Park and start the engine.
With the engine running at idle, observe meter
readings.
5. Increase engine RPM while observing ammeter and
tachometer.
6. Note RPM at which the battery starts to charge
(ammeter indication is positive).
7. With lights and other electrical loads off, the “break
even” point should occur at approximately 1500 RPM
or lower.
8. With the engine running, turn the lights on and
engage parking brake lock to keep brake light on.
9. Repeat test, observing ammeter and tachometer.
With lights on, charging should occur at or below
2000 RPM.
ELECTRICAL