HP37
Handbook
SL 4.0
4-step ventilation
MAIN SETTINGS (Run Mode)
VENTILATION TEMPERATURE SETTING.
Press
°C VENT
:
This messagge will be displayed instead of the
°Set
Ventilation temperature value
(start first speed)
.
Press
+
or
-
to modify, press
°C VENT
to confirm.
MINIMUM SPEED SETTING.
Press
MIN VENT
:
This messagge will be displayed instead of the
Minimum
Ventilation Speed.
Press
+
or
-
to modify, press
MIN
to confirm.
MAXIMUM SPEED SETTING.
Press
MAX VENT
:
This messagge will be displayed instead of the
Maximum
Ventilation Speed
.
Press
+
or
-
to modify, press
MAX
to confirm.
In normal condition ambient temperature is displayed and in setting coindition flashing
messagge appear.
The normal condition become again after exit from setting mode (auto-exit is performed
after 5 seconds from last key stroke in setting condition).
AMBIENT TEMPERATURE VIEWING
Press
+
: will be displayed followed by
°Maximum Temperature Recording.
Press
-
:
will be displayed followed by
°Minimum Temperature Recording.
VIEWING TEMPERATURE RECORDING
Values recorder are memory permanent stored: for memory clear keep pushed
+
keys
for more than 3 seconds:
CLEA
messagge will be composed on display before clearing
operation.
How to connect the line
Connect line on terminals
L-N
; protect supply with adeguate fuse.
How to connect the sensors
Connect the temperature probe provided as shown in the diagram. For remote
connections use a standard 0.5-square millimeter two-pole wire for each sensor,
taking great care over the connections, by insulating and sealing the joins carefully.
How to connect the contacts
Connect terminals
3-7
/
...11-13
on the terminal block (contacts up to 4AMP.AC1).
Output contacts are N.O. (Normally Opened and free of voltage) on wich is aplliable a
4AMP AC1 maximum load.
3-4= Speed 1 contact.
3-5= Speed 2 contact.
3-6= Speed 3 contatc.
3-7= Speed 4 contact.
11-12= Heat contact.
12-13= Cool contact.
*
Other power voltage if you required
COOL
COMMON
HEAT
HP37
230V LINE *
COMMON
SPEED 4
SPEED 3
SPEED 2
SPEED 1
SX TEMPER.
PROBE
INSTALLATION
As it company policy to continually improve the products the Manufacturers
reserve the right to make any modifications thereto without prior notice. They
cannot be held liable for any damage due to malfunction.
05.12.07
