FCC ID:
M5ZWOWPIR
Installation and Operation Instructions for the Point Six Wireless Sensor.
Point Six, Inc.
Wireless Sensor Model WOWPIR
Installation and Operation Instructions
The WOWPIR wireless Personal iButton Reader transmits a digital value representing
either the unique serial number of a touched iButton and a 16 bit field representing the ID
of the PIR to a 418 MHz receiver. The WOWPIR is enclosed in a high impact ABS
enclosure for direct surface mounting in the environment to be measured. WOWPIR is
battery operated
Application:
Touch the iButton reader port to the iButton to be read. The red LED will
flash to indicate a successful read and transmission of data.
Battery:
A 3.0 Volt lithium battery powers the WOWPIR wireless iButton reader. The
battery will last for more than 5 years in the idle state (as shipped from the manufacturer).
The WOWPIR will transmit data approximately 200,000 times before the battery must be
replaced. The WOWPIR is (other than the battery) covered with a water resistant rubber
coating to protect the electronics from the environment and condensation. The user can
replace the battery. The WOWPIR may be placed in a quiescent state (battery life greater
than 5 years) by covering the reader port with a nonconductive material such as tape.
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES, OPERATION IS
SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY
NOT CAUSE HARMFUL INTERFERENCE AND (2) THIS DEVICE MUST ACCEPT
ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY
CAUSE UNDESERED OPERATION
FCC ID: M5ZWOWPIR
MADE IN USA