0000111691/011121/B MonoGo
6
Fig. 4.2
C
H
G
E
F+G
D
A
I
B
A
D
F+G
E
H
A
B
B
C
D
D
E
F
F
G
G
Arm on stationary unit
4.5
Mounting of the hood
To install the extraction hoods, do the following.
Hose tube arm (Economy Arm): refer to Fig. 4.3
Metal tube arm (KUA): refer to Fig. 4.4
•
Loosen the mounting material that is attached to the hood
hinge.
• Install the extraction hood (G) with the bolt (F), 2 washers
(E), 2
spring washers
(D) and a locknut (C).
• Install the hood collar (H) to the hood (G). Fasten it with
the clip.
• Install the hose tube (A) to the hood.
• Fasten the hose tube with a hose clamp (B).
Fig. 4.3
C
A
B
F
G
H
D (2x)
E (2x)
D (2x)
Hood mounting (hose tube arm)
Fig. 4.4
C
A
F
H
G
D (2x)
D (2x)
E (2x)
Hood mounting (metal tube arm)
4.6
Switch box
• Install the switch box at an appropriate position.
• Connect the switch box to the filter unit and to
the mains in accordance with the separately
supplied electrical diagram.
5
USE
WARNING!
Fire hazard! Do
not
use the product for polishing
applications in combination with grinding, welding or
any other application that generate sparks.
Refer to chapter 3 / Safety instructions / Use.
5.1
Control panel
The MonoGo has a separate switch box to put the unit on and
off. Controls and indicators:
A
Buzzer (service indicator)
B Indicator light
C
Switch box with rotary switch 0/1
Fig. 5.1
A
B
C
0
1
Controls and indicators
5.2
Use
•
Position the hood of the connected extraction arm at max.
480 mm (19 in.) from the source of pollution.
IV on page 10 for the correct position.
• Make sure that the shut-off damper (ref. Fig. 2.1F) is open.
