Plustek NVR Slim380Pro, Руководство пользователя, Страница: 11 / 57

7
Chapter I. Setup the NVR
Before you setup the NVR, please make sure all components are available and ready.
A list of the package contents is provided in the Box Contents section of this guide. If
any items are damaged or missing, please contact the vendor where you purchased
your NVR or our customer service directly.
Attention
Please make sure a hard disk is installed in the NVR before you
use the NVR system.
Setup the NVR System
To set up the NVR system in your LAN environment:
Attention
Please properly configure the IP addresses of the NVR and the
IP cameras before connecting to the Switch. For example,
assuming the NVR’s IP address is 192.168.10.1, an IP camera’s
address should range from 192.168.10.2~240.
1. Connect IP cameras to the Switch’s LAN port.
2. Plug the RJ-45 connectors into the NVR’s LAN port and the Switch’s LAN port.
3. Plug the AC adapter into the DC-Jack of the NVR. Plug the other end of the
power cable into a standard AC power outlet. After the NVR has booted, it will
beep three times and the HDD indicator will blink slowly to indicate that the
hard disk has not yet been formatted for use.
Note : If no hard disk is installed when the NVR is powered on, the NVR will
beep every 10 seconds and the HDD indicator will blink slowly.
4. Press and hold the “Multi-function” button on the front panel of the device for 3
seconds to begin the fully automatic setup of the NVR. The hard disk will be
formatted first. The HDD indicator will blink quickly to indicate that the hard
disk format is in process.