M-11 Series Copyboard/C-11 Series Captureboard
Stand Assembly Manual
This is the stand assembly manual for the M-11 Series/C-11 Series.
Warning
• Please be sure to perform the installation and assembly based on this manual. Incorrect installation or assembly will be the cause of
injury.
• Please have 2 or more persons lift the Copyboard when installing or removing it.
• For details on installation, also refer to the copyboard’s “User’s Manual” and “Assembly and Setup Manual”.
STAND PAckAgiNg LiST
Please open the carton and check the parts.
In the rare event that something is missing, please contact your store of purchase.
T-shape legs (with casters)
×
2, Hexagonal socket screws
×
8, Flat washers
×
8, Horizontal bars
×
2, Hexagonal wrench
×
1, Stay
×
1, Nylon bushing
×
1,
M3
×
6 screws
×
2, Stabilizers
×
4, Frame caps
×
2, Auxiliary caps
×
4, Lock-screws
×
2
ASSeMbLy of The STAND
Frame Cap
Stabilizer
T-shape leg
Caster
Stabilizer
Use the same method to assemble the left and right sides of the stand.
(1) Press-fit the frame cap onto the top of the T-shaped
legs.
(2) Attach the stabilizers to the front and back of the
T-shaped legs.
insert the stabilizers securely all the way in.
(3) Lock the caster stoppers.
Press the bottom portion of the stoppers to lock them.
cAUTioN
To prevent toppling, be sure to install the stabilizers at each of the 4 loca-
tions. The toppling of this machine could cause bodily injury or damage the
machine.
(4) Attach the two horizontal bars to the
T-shape legs.
Use hexagonal socket screws (M5) and flat washers (M5) to attach.
Partially fasten using the hexagonal wrench (M5), then tighten securely
after the upper and lower horizontal bars have been attached.
Hexagonal wrench (M5)
T-shaped leg
Horizontal bar
Hexagonal socket screw (M5)
Flat washer (M5)
