Time to Assemble: Approximately 30 minutes
(Can be assembled by 1 adult, but better with 2)
Outdoor Use Only
Assembly Instructions
Step 1:
Assemble the Inner Spinner Head:
Assemble the inner most part of the Spinner Head. This requires the 3 thicker identical Spinner Blades provided and labeled as (L).
Gather all 3 Spinner Blades (L), the Main Rod
(J), 6 of the largest provided Screws (R), 6 Washers (S), and included Allen wrench (V).
Hold the Main Rod (J) with the exposed threaded end
facing up (this is the top of the Spinner Head).
Slide one of the Spinner Blades (L) on to the protruding knob on the bottom of the Main Rod (J).
Align the Spinner Blade (L) with the drilled holes on top of rod. You can tell that you inserted the Blade incorrectly if the top of the
Spinner Blade
won’t easily lay flat, and the holes, on both the top and the bottom of the Spinner Blade, will not align.
Using the provided Screw (R), Washer (S) and Allen wrench (V), tighten the screws in the appropriate bottom and top slots, placing the
Washer (S) in between the Spinner Blade and the Screw (see image for more detail).
Repeat above steps to attach the second and third Spinner Blades (L).
Step 2:
Assemble the outer part of the Spinner Head:
Gather all 3 Outer Helixes (N), 3 Screws (R), 3 Washers (S), 3 Medium Screws (O), the Allen wrench (V), and the included Phillips
Head screwdriver (U). Note: the Outer Helix (N) is the thinnest of the provided tubes.
Slide one of the Outer Helixes (N) into the appropriate spot on top of the main spinner head. The flat part of the Outer Helix should be
assembled on the top part of the Spinner Head. Keep in mind that the top of the Spinner Head has the exposed threaded end.
Align the Washer (S) with the provided hole and use the Allen wrench (V) to secure Screw (R) in place.
Secure Outer Helix (N) to the bottom of Spinner Head using medium sized Screw (O) and Phillips Head screwdriver. Repeat until all
three of the thinner Outer Helixes are attached.
Step 3:
Attach the Water Helix (P) to the outer part of Spinner Head.
Push the closed end of the Water Helix (P) into the opening at the top of Spinner Head. Make sure that the closed end of the Water
Helix is inserted to the top of the Spinner Head (exposed threaded end facing up). The closed end of the Water Helix will have an
already assembled washer and screw blocking the small hole.
Using the smallest flat Screw (T) and Phillips Head screwdriver, secure the Water Helix in place.
Push the open end of the Water Helix (P) into the appropriate opening at the bottom of the Spinner Head rod until it snaps snugly into
place. This should go in relatively smoothly. I
f it doesn’t, make sure you are not inserting the closed end of the Water Helix to the
bottom.
Repeat with the other two Water Helixes.
© 2017 Made in China exclusively for Plow & Hearth, Madison, VA 22727 plowandhearth.com 800-494-7544
54186 CO 89" HYDRO SPINNER
