3 / 9
OPERATION
•
Talk
- Use the
TALK
button to enable or disable talk for the device. This button changes with a
single, short press. “TK” appears on the LCD when enabled.
•
Volume Up and Down
- Use the
+
and
−
buttons to control the volume. “VOL” and a numerical
value from 00–09 appear on the LCD when volume is adjusted.
•
LED Modes
-
»
Left-hand Talk/State LED is blue and double blinks when logged in and single blinks when
logged out.
»
Right-hand Charging LED is red when battery is low and also red when charging in progress.
LED turns off when charging is complete.
OPERATING MULTIPLE MICROCOM SYSTEMS IN ONE LOCATION
Each separate MicroCom system should use the same Group for all belt packs in that system. Pliant
recommends that systems operating in proximity to one another set their Groups to be at least ten
(10) values apart. For example, if one system is using Group 03, another system nearby should use
Group 13.
BATTERY
The rechargeable Lithium-ion battery is installed in the device. Plug the USB charging cable into
the USB port to recharge the battery. The charging LED in the right top corner of the device will
illuminate solid red while the battery is charging and will turn off once the battery is fully charged.
The battery charge time is approximately 3.5 hours from empty. The belt pack may be used while
charging, but doing so may lengthen battery charge time.
