Pliant CrewCom CRP-44-2400, Руководство по эксплуатации

Страница: 33 / 76

Install Radio Pack Batteries
1. Hold the RP at about a 45-degree angle, pointing the bottom end down. Then, depress and hold the RP’s belt
clip down.
2. Lift open the battery door and remove it.
3. While still holding the RP at an 45-degree angle and depressing the belt clip, install a fully-charged Pliant
Lithium-Polymer rechargeable battery or three AA batteries.
Note : Radio Packs (RP) are powered with one Lithium-Polymer rechargeable battery for more
than 10 hours (2.4GHz) or 9 hours (900MHz), or they may be powered with three AA Alkaline
batteries for approximately 5 hours (2.4GHz) or 4.5 hours (900MHz).
4. Place the battery door back on the RP, making sure to align and insert its tab at the top first, and then secure
the door by pressing until it clicks. (Secure a magnetic door by pressing firmly until the magnet engages.)
5. Turn on the RP by pressing and holding the Power button on the back for three seconds.
Important : The RP will not communicate unless it has been paired to a Control Unit; if it has
not been paired it will indicate “No Pairing Information Available” on its display. In addition, the
RP will not communicate if its CU and RTs are not yet online. Pliant recommends powering on
CUs and RTs first before powering on RPs.
Figure 12 RP Rear and Battery Compartment Door
Setup and Installation - 26