Pliant CREWCOM CB2, Руководство по эксплуатации

Страница: 40 / 104

Install Radio Pack Batteries
1. Hold the RP at about a 45-degree angle, pointing the bottom end down. Then, depress and hold
the RP’s belt clip down.
(See Figure 12 below.)
2. Lift open the battery door and remove it.
3. While still holding the RP at an 45-degree angle and depressing the belt clip, install a fully-charged
Pliant Lithium-Polymer rechargeable battery (PBT-LIP-01) or three AA batteries.
Note : Radio Packs (RP) are powered with one Lithium-Polymer rechargeable
battery for approximately 10 hours (2.4GHz) or 9 hours (900MHz), or they may be
powered with three AA Alkaline batteries for approximately 5 hours (2.4GHz) or 4.5
hours (900MHz).
4. Place the battery door back on the RP, making sure to align and insert its tab at the top first, and
then secure the door by pressing until it clicks. (Secure the magnetic door by pressing firmly until
the magnet engages.)
5. Turn on the RP by pressing and holding the Power button on the back for three seconds.
Important : The RP will not communicate unless it has been paired to a
BaseStation; if it has not been paired, the Channel Button LEDs will indicate “No
Pairing Information Available” by blinking once. In addition, the RP will not
communicate if its BaseStation is not yet online. Pliant recommends powering on
BaseStations first before powering on RPs.
Setup and Installation - 33