16
vDisplay HDI-Pro IP Engine User Guide
Using GEVPlayer to Configure GigE Vision Compliant Devices
After you have assembled and powered up the hardware components, you can adjust the settings of the
vDisplay IP engine and the GigE Vision compliant video sources using the GEVPlayer application. We
recommend starting two sessions of GEVPlayer: one session to configure the video sources and one
session to configure the vDisplay IP engine.
Ensure that you have installed version 1.3.3 (or later) of the eBUS SDK with GEVPlayer (formerly called the
eBUS PureGEV SDK suite) on the PC or laptop.
It is possible for you to configure the vDisplay IP engine and GigE Vision compliant video sources using
other GenICam-compliant software, however, this guide provides you with the instructions you need to
use the Pleora GEVPlayer application.
It is important to connect the vDisplay IP engine to the same subnet as the network card of the PC used
to configure the vDisplay IP engine. If it is not on the same subnet, the vDisplay IP engine might not
appear within the GEVPlayer application. You can locate the vDisplay IP engine by clicking
Show
unreachable GigE Vision Devices
, as shown in the following image.
