Pleion EGO 110, Инструкция по установке и эксплуатации

Страница: 62 / 67

Installation and user handbook – rev.0.4 of 23.02.2017
62
INSTALLING THE ELECTRIC RESISTORS
If electric resistors are to be installed after the collector has been started, it must be
covered previously with the supplied cover sheet (or with a suitable darkening system) and
emptied completely.

The integration resistor (1 and 2 kW) must be installed in the upper part of the solar
collector, opposite the side where the outflow connection is positioned (I).

The antifreeze resistor (0.3 kW) must be installed in the lower part of the solar collector,
opposite the side where the inflow connection is positioned (L).
Using a plastic spanner of 1"1/4, unscrew the plastic cap, being careful not to
damage it and making sure that the O-ring remains in its seat.
Insert the resistor into the hole and tighten it by hand, without using tools; the
structure of the resistor and its connection to the solar collector collector were designed to
avoid their use. Tightening by hand is enough to guarantee system sealing.
Do not use any type of tool to tighten the electric resistor; using tools can
damage the sealing thread, resulting in the appearance of leaks. In this case, the
manufacturer will not recognise any guarantee rights.
Connect the power cable to an electric socket and check the earthing connection.