Plasson PFS Monomatic, Инструкция по эксплуатации

Страница: 25 / 68

EN001 H01 25
11.2.3 Other display messages
After the startup display is shown, other messages might be displayed before the main display is shown.
11.2.3.1 System config. at last welding process
If the system configuration is changed before the next restart of the electrofusion control unit, a message in
the display is shown which indicates, that the system configuration has been changed and what was
changed. This is also stored in a report.

This message is acknowledged by pressing the red stop button.
11.2.3.2 Error occurred
If an error during or before the last welding has occurred (for example resistor error), a special message will
appear in the display as a reminder.

This message is acknowledged by pressing the red stop button.
1 Example
1.1 The following example is meant to show how the device will indicate that an error has occurred
before switching the electrofusion control unit off.
Display after switching on
Attention!
These messages do not show current errors/problems. They are only meant to remind the
user that an error/ problem occurred before the electrofusion control unit was switched off
the last time!
11.2.3.3 Service
This message is displayed as soon as the service interval has passed. This can happen, if the set time for
the service interval (e. g.12 months) has passed, or, for electrofusion control units with no data recording,
after 200 operating hours.

This message is acknowledged by pressing the red stop button.
Attention!
It is recommended to send the electrofusion control unit in for service as soon as this message
appears. The display of this message is a recommendation or reminder to you, that the service
interval of the electrofusion control unit is reached. The display of this message does not mean,
that the electrofusion control unit cannot be used anymore before service.
By acknowledging with a press on the red stop button the electrofusion control unit switches back
to the main display.
Resistance error
at last welding proc
ess