Planmeca PlanMill 40 S, Руководство пользователя, Страница: 21 / 32

Planmeca PlanMill 40 S User Manual Importing for Milling 21
Mill Screen
This section contains specific instructions for imported restorations. For full Mill screen instructions, see the PlanCAD manual.
Specify the Material
1 Click Settings in the top right corner.
2
Click
Material/Shade Settings.
3
Use the arrows to select the
Material, Translucency, and Shade.
4 Click Save.
Select a Block Size
Available block sizes are listed in the Blocks section. A default size is selected. Click on another size if
desired. If the restoration will not fit into any of the block sizes available in the chosen material, click
Settings to select a different material.
Sprue Placement
Change the location of the sprue on the restoration, if desired, by moving the placement indicator (circled in orange below) along
the circle that represents the exterior of the restoration or by clicking one of the arrows. Recommended locations are as follows.
• Anteriors/posteriors: midway between lingual and the mesial or distal
• Premolars: mesial or distal
• Inlays and Onlays: largest proximal box
A
Restoration
B
Sprue
C
Mandrel
The sprue is the connection between the restoration and the mandrel.
Rotate and inspect the restoration to ensure the sprue is not positioned on a groove. Move the sprue towards a flatter area of the
restoration. This is usually near the interproximal, but should not be put on the contact area unless it is necessary. It must be a full
round sprue, at an angle never straight buccal and never straight lingual . Placed away from the margin. If you need a smaller block
option try a straight inter-proximal placement
High, away from margin and
contact areas.