Planmeca Compact i3, Руководство по установке

Страница: 7 / 106

2 Pre-installation requirements
CAUTION
Do not connect items which are not specified as part of the system.
CAUTION
Do not connect a Multiple Portable Socket-Outlet or extension cord to the
system.
2.1 Floor strength
NOTE
The dealer must check the floor material and strength of the installation site
before the installation.
The floor must be straight within 1%. Antistatic floor materials should be
preferred.
The concrete floor must be 50mm (2in.) thick. The concrete strength must be
type C20/25-C50/60 (According to standard EN 206-1:2000), non-cracked
concrete.
With concrete floor, the unit can be installed without installation plate.
The required attachment hardware depends on the floor material. The
attachment hardware, as well as floor material must endure a pullout force of
5900 N.
The person installing the unit is responsible for using the appropriate
attachment hardware and ensuring the sufficient pullout strength of the floor.
Consult a local structural engineer if necessary,and always follow local
construction regulations.
2.2 Environmental requirements
2.2.1 Transportation conditions
Accepted limits for unit transportation are the following:
•
Temperatures: -20 °C to +60 °C (-4 °F to 140 °F)
• Relative humidity: 5% RH to 95% RH “Absence of condensation”
• Air pressure: 700 hPa to 1060 hPa (10 psi to 15 psi)
2.2.2 Storage conditions
Accepted limits for unit storage are the following:
•
Temperatures: -5 °C to +60 °C (23 °F to 140 °F)
• Relative humidity: 5% RH to 95% RH “Absence of condensation”
• Air pressure: 700 hPa to 1060 hPa (10 psi to 15 psi)
NOTE
If the unit has been stored at temperatures below +10 °C (50 °F) for more
than few hours, time must be allowed for the unit to reach the room
temperature in its own package, before connecting the dental unit to mains
voltage.
2 Pre-installation requirements
Installation manual Planmeca Compact i3 3