Planmeca Compact I, Техническое руководство

Страница: 24 / 244

Chapter B - CONTROL PANEL FUNCTIONS
B-4 Planmeca Compact i
PROGRAMMING MODE FUNCTION DETAILS
Technical Manual
4 PROGRAMMING MODE FUNCTION DETAILS
4.1 Automatic chair positions
The chair must be in the desired position to be programmed before entering the programming
mode. If not, please first move the chair to the position required using the chair foot control or
the chair keys on the unit control panel.
a) Press the program key.
b) Press the desired chair position key where to store the chair’s position (S, A, B, C or D).
Switch the operating light on or off for this position. Note that if you are programming the
spittoon position, you can not select the operating light setting.
c) The text ‘PoS.n’ will appear on the display (n can then be either A, b, C, d or S).
d) Press the program key to store the chair position into the memory. The indicator light will go
out.
4.2 Instrument spray flow rates
Since the adjustment is individual for each instrument, you must indicate which instrument to
program by picking it out from the holder.
a) Press the program key.
b) Press the instrument spray key. The text ‘SA.nn’ or ‘SH.nn’ will appear on the display
indicating which of the parameters will be adjusted (A for air and H for water).
c) Press the spray key repeatedly (or the foot control pedal briefly down) to toggle between air
and water adjustment.
d) Change the flow rate with the help of the foot control pedal. Bringing the pedal to the right will
increase the flow, taking it to the left side will decrease the flow. Please note that the
instrument will run normally during this operation. Turbines will start immediately to full speed.
e) Press the program key to exit and store the new spray settings.
S
C
D
A
B
PoS.A
SA.35
+
-