– 1 –
– 2 –
– 3 –
– 4 –
1. Overview
Thank you for purchasing PLANET 150-watt DC -48V power
supply.
Power Supply Unit
Input Range
XGS3-PWR150-48
-40 to -60V DC
Open the box of the Redundant Power Supply unit and
carefully unpack it. The box should contain the following
items:
The -48V DC Power Supply unit x 1
User’s Manual x 1
If any item is found missing or damaged, please contact
your local reseller for replacement.
2. Introduction
Before installation, please be sure to read this user’s
manual carefully to complete machine installation. This
manual shows how to quickly install the power from the
XGS3-24042, unless specified as
“redundant power”
that
will be used for these four models.
The following figure illustrates the front panel of the
XGS3-PWR150-48.
4.7 -2.8A
-40 --60V
Figure 2-1
XGS3-PWR150-48 Front View
LED
Color
Function
LNK/ACT
Green
Lights to indicate DC power input has
power.
Red
Blinks to indicate DC power input has
failed or warning.
3. Installing Redundant Power Supply
Unit
Note
The XGS3-PWR150-48 is hot-swappable during
operation; there is no need to power off the
Switch before sliding or removing the module.
Follow these steps to install the redundant power into the
Switch:
1. Place the Switch on a flat surface. Grasp the thumbscrew
on the sides of the blank bracket and turn counter-clock-
wise to unscrew them. You can also use a screwdriver
to remove the blank bracket. Do not discard the blank
bracket. Put the blank bracket back if you remove the
module out of the Switch.
Figure 3-1
Removing the blank bracket
2. Install the redundant power by inserting it into the rails
and sliding it.
Figure 3-2
Inserting the XGS3-PWR150-48
3. Hear the redundant power snap in place to finish inser-
tion.
Figure 3-3
Inserting the XGS3-PWR150-48
4. Wiring the DC Power Input
The 3-pin terminal block connector on the redundant power
uses DC power input. Please follow the steps below to
insert the power wire.
Note
1. Before connecting the DC power wires, please
check whether your local DC power source is
stable.
2. The wire gauge for the power cable should be in
the range of 12 ~ 24 AWG.
3. The DC power input range is -40 ~ -60V DC.
