5.1.3 Remote
Management
You can specify a Host IP address that can perform remote management from Internet.
Parameters
Description
Host Address
The IP address of the host on Internet that will have management / configuration
access to the Broadband router. Leave it to
0.0.0.0
means anyone can access the
router’s web-based configuration from any remote location.
Click the
Enabled
box to enable the Remote Management function.
Note:
When you want to access the web-based management from a remote site, you
must enter the router’s WAN IP address (e.g. 10.0.0.1) into your web-browser followed
by port number 8080, e.g. 10.0.0.1:8080 (see below). You’ll also need to know the
password set in the Password Setting screen in order to access the management
pages.
After the setup completed, please click “Apply” to save the settings. After press “Apply”, you will see a
web screen to prompt you the configurations save successfully. You may refer to section 4.2.7 for the
information of this screen.
- 22 -
