User Manual of WAP-252N/WAP-552N
-12-
Chapter 3. Hardware Installation
Important Safety Precautions
3.1
1)
LIVES MAY BE AT RISK!
Please be aware of the electrical wires around. Carefully read the section
"
OUTDOOR INSTALLATION WARNING
" in the manual before installation.
2) Users
MUST
complete grounding wired with the device; otherwise, a sudden lightning could cause fatal
damage to the device.
EMD (Lightning) DAMAGE IS NOT COVERED UNDER WARRANTY.
3) Users
MUST
power off the device first before connecting the antenna to it; otherwise, damage might be
caused to the device itself.
4) The Antenna and Surge Arrestor are required for each antenna connector, and must be purchased separately.
Installing the Outdoor Access Point
3.2
Please install the AP according to the following steps. Don't forget to pull out the power plug and k eep your
hands dry.
Step 1.
Loosen the socket head screw on the left-side of the device and insert the L-type bracket. Then,
secure the screws.
Step 2.
Position the device on a pole and secure it by using the two U-bolt kits to finish the installation.
The AP can be mounted on an up to 2.5” (O.D.) pole