Get to know the Wireless VPN Firewall Router
Back Panel
The diagram (fig1.0) below shows the VRT-401G’s back panel. The router’s back panel is divided
into three sections,
LAN
,
WAN
and
Reset
:
Figure 1.0
1) Local Area Network (LAN)
The VRT-401G’s 4 LAN ports are where you connect your LAN’s PCs, printer servers, hubs
and switches etc.
2) Wide Area Network (WAN)
The WAN port is the segment connected to your xDSL or Cable modem and is linked to the
Internet.
3) Reset
The Reset button allows you to do one of two things.
1) If problems occur with your router, press the router’s reset button with a pencil tip (for
less than 4 seconds) and the router will re-boot itself, keeping your original
configurations.
2) If problems persist or you experience extreme problems or you forgot your password,
press the reset button for longer than 4 seconds and the router will reset itself to the
factory default settings (
warning
: your original configurations will be replaced with
the factory default settings)
Front Panel
On the router’s front panel there are LED lights that inform you of the router’s current status.
Below is an explanation of each LED and its description.
Figure 1.1
LED
Light Status
Description
PWR
ON
Router’s power supply is on
WAN
10/100M
ON
WAN port 100Mbps is connected
OFF
WAN port 10Mbps is connected
WAN
LNK/ACT
ON
WAN is connected
OFF
No WAN connection
Flashing WAN port has Activity (ACT), data being sent
6
Содержание VRT-401G
Страница 1: ...54M Wireless VPN Firewall Router VRT 401G User s Manual 1...
Страница 37: ...AP Mode setting Page Station Ad Hoc mode setting page 37...
Страница 38: ...Station Infrastructure mode setting page AP Bridge Point to Point mode setting page 38...
Страница 39: ...AP Bridge Point to Multi Point mode setting page AP Bridge WDS mode setting page 39...
