Planet VRT-401G, Руководство пользователя

Страница: 31 / 86

Host Address This is the IP address of the host in the Internet that will have
management/configuration access to the VRT-401G from a remote site.
This means if you are at home and your home IP address has been
designated the Remote Management host IP address for this router
(located in your company office), then you are able to configure this
router from your home. If the Host Address is left
0.0.0.0 this means
anyone can access the router’s web-based configuration from a remote
location, providing they know the password.
Click the Enabled box to enable the Remote Management function.
Note : When you want to access the web-based management from a
remote site, you must enter the router’s WAN IP address (e.g. 10.0.0.1)
into your web-browser followed by port number 8080, e.g.
http://10.0.0.1:8080. You’ll also need to know the password set in the
Password Setting screen in order to access the router’s web-based
management.
Port The port number of remote management web interface.
Enabled
Select “Enabled” to enable the remote management function.
Click < Apply> at the bottom of the screen to save the above configurations. You can now
configure other advance sections or start using the router (with the advance settings in place)
2.2 WAN
Use the WAN Settings screen if you have already configured the Quick Setup Wizard section and
you would like to change your Internet connection type. The WAN Settings screen allows to
specify the type of WAN port connect you want to establish with your ISP. The WAN settings offer
the following selections for the router’s WAN port,
Dynamic IP , Static IP Address , PPPoE ,
PPTP , L2TP , Telstra Big Pond , DNS and DDNS .
31