Page 45 of 97
a.
Interface
– Click on
“Interface”
drop down menu to select interface.
b.
Subnet
– Enter the interface network address.
c.
IP Start
– Enter the IP address of IP start.
d.
IP End
– Enter the IP address of IP end.
e.
Netmask
– Enter the network mask for this network address.
f.
Max Lease
– Enter the value of Max Lease.
g.
Lease
– Enter the value of Lease.
h.
Domain
– Enter the name of Domain.
i.
DNS
– Enter the network address of DNS.
j.
Router
– Enter the network address of Router.
k.
Comments
– Enter the DHCPD comments.
l.
Active
– Click on
“Active”
drop down menu to select enable or disable this interface.
m.
“Apply”
button – Click on
“Apply”
button to confirm add DHCPD. New settings are
active after the device reboot.
n.
If you select to edit existing DHCPD, a page similar to Figure 3.4.1.2 with configured
settings will be displayed.
3.4.2
Service > Firewall
(MAP-3100 only)
Firewall is used to allow or deny data either in or out. Firewall configuration page is shown in
Figure 3.4.2.1.
Figure 3.4.2.1: Firewall configuration page
To configure Firewall:
a.
Click on
“Active”
drop down menu to enable or disable Firewall service.
