Page 35 of 97
3.3.5
Network > Wireless
AP configuration page is shown in Figure 3.3.5.1.
Figure 3.3.5.1: AP configuration page
To configure wireless AP interface:
A. Mac address displays the MAC address of interface.
B. Mode displays the operating mode: AP.
C. Click on
“Band”
drop down menu to select “802.11a”, “802.11b” or “802.11g” operating
band.
D. Click on
“Frequency”
drop down menu to select operating frequency of the wireless
network in Mhz.
E. Click on
“Tx antenna”
drop down menu to select “Diversity”, “Port 1”, “Port 2” or “Card
Default”.
F.
Click on
“Rx antenna”
drop down menu to select “Diversity”, “Port 1”, “Port 2” or “Card
Default”.
G. Current Tx Power shows current transmit power of the wireless card due to regulatory
limitation
H. Select Tx Power of the AP wireless card.
I.
Click on
“Apply”
button if you have made any changes. New settings are active after the
device reboot.
