2 Mega-pixel 35M IR Outdoor Box PoE IP Camera
ICA-HM351
95
Appendix F: Troubleshooting &
Frequently Asked Questions
Features
The video and audio codec is
adopted in the device.
The device utilizes H.264 and MJPEG triple compressions to provide
high quality images. Where H.264 is standard for video compression,
MJPEG is a standard for image compression.
The audio codec is defined as AMR for 3GPP and G.711/G.726 for
RTSP streaming.
The maximum number of users that
accesses the device
simultaneously.
The maximum number of users is limited to 8. However, it also
depends on the total bandwidth accessed to this device from clients.
The maximum data throughput of the device is around 20~25Mbps
for UDP mode and 10Mbps for HTTP mode. Therefore, the actual
number of connected clients is varying by streaming mode, settings
of resolution, codec type, frame rate and bandwidth. Obviously, the
performance of the each connected client will slow down when many
users are logged on.
The device can be used outdoors or
not.
The device is weatherproof and could be installed outdoor.
Installing this device
Status LED does not light up.
Check and confirm whether the DC power adaptor, included in the
package, is used. Secure the power connector and power it on again.
The network cabling is required for
the device.
The device uses Category 5 UTP cable allowing 10 and/
100BASE-TX networking.
The device will be installed and
work if a firewall exists on the
network.
If a firewall exists on the network, port 80 is open for ordinary data
communication. The HTTP port and RTSP port need to be opened on
the firewall or NAT router.
The username and password used
for the first time or after factory
default reset
Username =
admin
and password =
admin
.
Note that it’s all case sensitive.
Forgot the username and password
Follow the steps below.
(1)Remove power, and press and hold the button in the back of IP
camera.