HD Ultra-mini Bullet IR IP Camera
ICA-3110
Chapter 2. Hardware Interface
2.1 Physical Descriptions
Real Panel
Interface
Description
LAN(PoE)
The LAN socket is a RJ-45 connector for connections to
10Base-T Ethernet or 100Base-TX Fast Ethernet cabling.
This Ethernet port built N-Way protocol can detect or
negotiate the transmission speed of the network
automatically. Please use Category 5 cable to connect the
Network Camera to a 100Mbps Fast Ethernet network
switch or hub.
Micro-SD
User can insert a micro SD card into this slot for event
recording.
Factory Default Reset
This button is hidden in the pinhole. This button is used to
restore the all factory default settings. Sometimes restarting
the camera will make the system back to a normal state. If
the system still got problems after restart, user can restore
the factory default settings and install it again. To restore
the device, please follow the steps below:
1. Unplug the power jack, then press and hold the reset
button.
2. Power on the camera. Don’t release the button during
the system booting.
3. It will take around 30 seconds to boot the camera.
4. Release the button (remove the pin from the reset
hole). The camera should now be back to factory
default.
5. Login the camera using the default IP
(
), and username (admin), password
(admin).
Restoring the factory default setting will lose all
the previous settings including IP address
forever. User needs to run the IPInstaller
program to search the device and configure it to
let the device work properly again.
DI/DO
Connect the power and the Ethernet with the camera. The
12