– 1 –
– 2 –
1. Package Contents
Thank you for choosing PLANET GPON ONT. Before installing the
range extender, please verify the contents inside the package box.
GPN-100
User’s manual
Power adapter
(12V, 0.5A)
Note
If there is any item missing or damaged, please contact
the seller immediately.
2. Physical Introduction
Top View and LEDs
PON
LAN
POWER
LOS
LED Indicators
LED
Color Function
PWR
Blue
Lights Indicates the ONT has power.
OFF
The ONT doesn’t receive power.
LOS
Red
Blinks Optical Power is too low.
OFF
Optical Power is normal.
PON
Blue
Blinks
Indicates the port is not getting normal
Optical Signal.
Lights
Indicates the port is getting normal
Optical Signal.
LNK/ACT Blue
OFF
No link
Blinks
Indicates the link through that port is
actively sending and receiving data.
Lights
Indicates the link through that port is
successfully established.
Rear View
Power
Button
10/100/1000BASE-T
RJ45 LAN Port
GPON Port
SC/UPC
Power
Socket
Reset
Button
Bottom View
3. Hardware Installation
Safety Requirements
z
Never look directly into the ends of fiber or PON modules. The
emitted light could cause damage to the eye.
z
Make sure the GPON service is enabled.
z
Ensure that the optical fiber is long enough to achieve the
desired installation place.
z
Put the ONT on a sturdy table.
z
Don't open the device when the ONT is operating.
z
Contact your local agent for permission if you want to remove
the chassis.
z
Allow about 10cm of clearance around the ONT chassis for heat
dissipation.
Step 1:
Connecting the RJ45 network cable.
a. Plug in the RJ45 cable to 10/100/1000 GE port.
b. Plug in the other side to your host or devices.
Step 2:
Connecting the fiber cable.
a. Remove the protective cap of the optical fiber.
b. Remove the protective cap of the ONT optical interface
(PON interface). Insert the fiber into the PON interface.
Warning
Don’t
connect the ONT/HGU directly to GPON SFP
module
(GPL-GSFP-C+ or GPL-GSFP-C++)
. Doing
so will damage the ONT/HGU optics. Use a PON
splitter to add attenuation as needed.
Note
1. Keep the optical connector and the optical fiber
clean.
2. Make sure the bending diameter of the fiber is more
than 6cm. Otherwise, the optical signal loss may be
increased.
3. Cover a protective cap to guard against dust and
water when the fiber is not used
Step 3:
Connecting Power Adapter.
a. Connect the power adapter to the power socket on the
ONT.
b. Insert the other end into a power outlet.
OLT/
Splitter
Fiber
Power
Power
Adapter
PC
Router
PC
Switch
